John Deere 230LCR, 230LCRD — APPENDIX A

TM 5-3805-280-10 OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SERVICES FOR HYDRAULIC EXCAVATOR 230LCR/230LCRD A-9 ITEM NO. INTERVAL ITEM TO BE INSPECTED PROCEDURE: DO THE PMCS AND HAVE ITEM REPAIRED, FILLED, OR ADJUSTED AS NEEDED EQUIPMENT IS NOT READY/AVAILABLE IF: 21 Before Check Recovery Tank Coolant Level NOTE: On Model 230LCRD, the overflow lines for the main engine and compressor engine radiators are connected to a common recovery tank. (1) Open left rear access door. (2) With engine cold, coolant level must be at the FULL mark on the recovery tank (A). (3) If coolant is below the FULL mark, add coolant to the recovery tank. WARNING: Prevent possible injury from hot spraying water.

DO NOT remove radiator filler cap unless engine is cool. Then turn cap slowly to the stop. Release all pressure before you remove cap. NOTE: If recovery tank is empty, check for leaks. Repair as required. Add coolant to the radiator(s) and the recovery tank. NOTE: Coolant level in radiator(s) must be at bottom of the filler neck. NOTE: If recovery tank is full and radiator(s) is low, check for leaks in radiator cap and the connections between radiator and recovery tank. Coolant does not cover cooling tubes in top of radiator