Komatsu — eebm001902 a3.pdf

TROUBLESHOOTING METHOD OF USING TROUBLESHOOTING CHARTS (1) M-8 When starting switch is turned ON (engine stopped), basic check items flash (2) # Before carrying out troubleshooting, check that all the related connectors are properly inserted. # Always connect any disconnected connectors before going on to the next step. (3) a) (coolant level) flashes b) (engine oil level) flashes (4) Table 1 20-95 YES 1 Does display go out 4YES when short connec- tor is connected to Is bit (3) of P08 (female)? YES monitoring code 24 3 lighted up? • Disconnect P08. Is continuity between • T Ou Nrn . starting switch YES C ch1 a6 s ( sf ie sm aa sl e s) h o(8 w) na n ind • Turn starting switch NO ON. 2 table?

• Set to monitoring code 24. Is there continuity • Turn starting switch between P08 (female) OFF. NO NO (2) and chassis? • disconnect C16, P08. • ConnectrR discon- nnect short connec- • Turn starting switch tor to P08 (female). OFF. • Disconnect P08. NO Cause Remedy Defective coolant level sensor system (see M-26) Defective governor, pump controller Defective monitor panel Defective contact, or disconnection in wiring harness between C16 (female) (8) -P08 (female) (1) Defective contact, or disconnection in wiring harness between P08 (female) (2) - chassis ground - Replace Replace Repair or replace Repair or replace Short connector Continuity Connected Yes Disconnected No