DISASSEMBLY AND ASSEMBLY TRACK SHOE REMOVAL OF TRACK SHOE ASSEMBLY 1. Positioning track shoe # Stop the machine at a point where it is easy to set master pin removal tool I and where master pin is in the middle of the track frame, then loosen lubri- cator (1), and relieve the track tension. 1 The adjustment cylinder is under extremely high pressure, so never loosen the lubricator more than one turn. If the grease does not come out, move the machine backwards and forwards. 2. Using tool I pull out master pin (2). 2 3. Lay out track as follows.
1) Move machine forward so that position of tempo- rary pin is at front of idler, set block a in position, then remove temporary pin b , and remove dust seal. 2) Drive machine in reverse to lay out track. 3 INSTALLATION OF TRACK SHOE ASSEMBLY Carry out installation in the reverse order to removal. 1 Adjust the track tension. For details, see TESTING AND ADJUSTING, Testing and adjusting track tension. 2 # Use tool I and press fit so that the protrusion of the master pin is dimension “ a Protrusion “ a ” of master pin: 4.2 ± 2 mm 3 When assembling the dust seal,coat the bushing contact surface with grease (G2-LI). 30-82