Komatsu — eebm001902 a3.pdf

DISASSEMBLY AND ASSEMBLY MAIN PUMP 6. Disconnect pump servo pressure hose (12) and pump drain hose (13), and remove intermediate clamp (14) of hose. # Protect with the sleeve nut to prevent damage to the nipple or elbow taper seal portion. 7. Disconnect suction tube (15) at pump end. # Cover the suction tube port portion with plastic. 8. Remove engine partition plates (16), (17) and (18). 9. Remove muffler drain pipe (19) and clamp mounting bracket (20). 10. Remove main pump assembly as follows. a. Leaving 2 - 3 mounting bolts, remove other mounting bolts. b. Sling main pump assembly and install 2 guide bolts 1* on diametrically opposite sides. c.

Remove remaining mounting bolts, then pull out slowly until main pump assembly separates from spline shaft. d. Lift off main pump assembly. 1 Main pump assembly: 150 kg 30-86