DISASSEMBLY AND ASSEMBLY BOOM Installation Carry out installation in the reverse order to removal. 1 # When tightening the locknut, tighten so that the clear- ance between the plate and nut is 0.5 mm - 1.5 mm. 2 Inside surface of bushing when assembling pin: anti-friction compound (LM-P) Greasing after assembling pin: Grease (LM-G) When aligning the position of the pin hole, never insert your fingers in the pin hole. # Adjust the shim thickness so that the clearance be- tween cylinder rod (10) and plate (11 ) is below 1 mm. # Standard shim thickness: 0.8 mm, 1.5 mm. 3 Inside surface of bushing when assembling pin: anti-friction compound (LM-P) Greasing after assembling pin:
Grease (LM-G) When aligning the position of the pin hole, never insert your fingers in the pin hole. # Adjust the shim thickness so that the clearance be- tween boom (12) and bracket (13) is below 1 mm. # Standard shim thickness: 0.8 mm, 1.0 mm, 1.5 mm. Refilling with oil (hydraulic tank) # Add oil through the oil filler to the specified level. Run the engine to circulate the oil through the system. Then check the oil level again. Bleeding air # Bleed the air from the cylinder. For details, see TEST- ING AND ADJUSTING, Bleeding air from hydraulic cylinder. 30-130