E-3: INSTALLATION OF ARM CYLINDER TOP PIN 1. Remove the stopper fitted to the arm, then re- move the arm cylinder top pin. & kg Arm cylinder top pin: 25 kg * Use a forcing screw (Dia. = 16 mm, Pitch = 2.0 mm) to remove the pin. 2. Raise the boom and arm with a crane, align with the arm hole, and push in the pin. &?I Boom assembly: 6700 kg kg Arm assembly: 4500 kg & Inside of bushing: Anti-friction compound (LM-PI * Assemble so that the greasing hole in the arm cyl- inder top is facing down, 3. Install on the left and right in the same way. 4. Install the stopper. 5. Remove the nylon sling holding the arm cylinder. Be careful not to damage the grease piping 100