E-4:INSTALLATION OF BUCKET CYLINDER FOOT PIN 1. Remove the stopper fitted to the boom, then re- move the bucket cylinder foot pin. * Use a forcing screw (Dia. = 16 mm, Pitch = 2.0 d?!] Bucket cylinder foot pin: 49 kg mm) to remove the pin. 2. Insert O-rings (~07000-12130 x 4) in the O-ring grooves of the 2 bushings of each cylinder at the bucket cylinder foot. 3. Fit a nylon sling to the bucket cylinder, raise it with a crane, align it with the pin holes at the boom end, then push in the pin. 4 Inside of bushing: Anti-friction compound (LM-P) * Assemble so that the greasing hole in the bucket cylinder foot is facing down. &T Bucket cylinder assembly: 710 kg ti 4.
Install on the left and right in the same way. 5. Install the stopper. Front of machine _ 101