D-7: INSTALLATION OF BOOM CYLINDER TOP PIN 1. Remove the stoppers fixed to the boom, then re- move the boom cylinder top pin. & kg Boom cylinder top pin: 42 kg &FYI kg Boom cylinder assembly: 1150 kg Start the engine and run at low idling. the pin hole, then push in the pin. Raise the cylinder, extend the rod slowly to align Check the clearance between the end of the boom boss and the end of the cylinder boss. Select a shim thickness to make the clearance 2 - 3 mm, and assemble the shims. Knock in the cylinder top pin. 6 Inside of bushing: Anti-friction compound (LM-P) * When operating the cylinder, extend it slowly.
Do not operate the cylinder suddenly or operate At first there is air inside the cylinder, so the cyl- it to the end of its stroke. inder may not move for the first ten seconds. In its travel. such cases, do not operate the lever to the end of 7. Install the stopper. 6. Install the left and right cylinders in the same way. Parts sent individually Part No. Part Name Q’ty 21 N-72-l 1230 Shim (tl.0) 2 80