Change Pilot Filter NOTE: Change pilot filter after first 250 hours of operation or rebuild, and every 1,000 hours thereafter. FG013895 Figure 83 WARNING AVOID DEATH OR SERIOUS INJURY The hydraulic oil will be hot after normal machine operation. Allow the system to cool down before changing pilot filter. 1. Park machine on firm and level ground. Lower the front attachment to the ground and stop engine. 2. Lift the breather cap (1, Figure 81) slightly to release the internal pressure. 3. Locate pilot system filter assembly. 4. Unscrew canister (2, Figure 84) and remove O-ring (3) and filter cartridge (4). 1 NOTE: The canister will be filled with oil. Use caution when removing this assembly.
5. Insert a new filter cartridge and O-ring. Apply a small amount of oil around the entire O-ring and install the canister assembly onto the filter head (1, Figure 84). 3 4 NOTE: Used filter should always be disposed of according to local regulations. 2 6. After changing pilot filter, vent air from pump and check level of hydraulic oil tank. Figure 84 DS1703795 Inspection, Maintenance and Adjustment 4-49 DX140R/DX140LCR