Komatsu — AIR CLEANER ELEMENT-CHECK/CLEAN/REPLACE

MAINTENANCE PROCEDURE MAINTENANCE 4. If small holes or thinner parts are found on the element when it is checked by shining a light through it after cleaning, replace the element. NOTICE When cleaning the element, do not hit it or beat it against something . Do not use an element whose folds or gasket or seal are damaged. Wrap unused element and store them in a dry place. 5. Remove the cloth and tape used for cover in Step 1. 6. Install the cleaned element and fix it with the wing nut. 7. Replace seal washer (4) or wing nut (2) with new parts if they are broken. 8. Remove vacuator valve (5) and clean with compressed air. After cleaning, install again. 9.

Press the button of dust indicator to return the red piston to its original position. Replacing element 1. Open the engine food on the rear of the machine, remove wingnut (2) and take out element (3) . To prevent entry of dirt and dust, cover the air connector side of the rear end of the air cleaner with a clean cloth and adhesive tape. 2. Clean the air cleaner body interior, then remove the cover installed in Step 1. 3. Install a new element and fix it with wing nut (2) . 4-20