Komatsu — FUEL FILTER CARTRIDGE-REPLACE

MAINTENANCE PROCEDURE MAINTENANCE Fuel Filter Cartridge - Replace WARNING The parts are at high temperature immediately after the engine has been operated. Wait for all parts to cool down before replacing the filter. Do not bring fire or sparks near the fuel. Prepare a filter wrench and a container to catch the fuel. 1. Set the container to catch the fuel under the filter car- tridge. 2. Using a filter wrench, turn filter cartridge (1) counterclock- wise to remove it. 3. Clean the filter holder, fill a new filter cartridge with clean fuel, coat the packing surface with engine oil, then install it to the filter holder. 4.

After bringing the packing surface into contact with the seal surface of the filter holder, tighten it a further 2/3 turns. If the filter cartridge is tightened too far, the packing will be damaged and this will lead to leakage of fuel. If the fil- ter cartridge is too loose, fuel will also leak from the pack- ing, so always tighten to the correct amount. 5. After replacing the fuel filter cartridge, bleed the air from the system. Bleed the air as follows. 6. Fill the fuel tank with fuel (to the position where the float is at the highest position). 7. After replacing filter cartridge (1), loosen air bleed plug (2). 8.

Loosen the knob of feed pump (3), pump it up and down, and continue to make the fuel overflow until no more bubbles come out from joint bolt (2). 9. Tighten joint bolt (2). Always use a genuine Komatsu filter cartridge. After replacing the filter cartridge, start the engine and check for any leakage of oil from the filter seal sur- face. REMARK Use the same procedure to operate the feed pump and bleed the air if the machine runs out of fuel. 4-62