OPERATION 12.16 HYDRAULIC QUICK COUPLER WARNING Ensure that attachments are properly attached prior to operating the machine. Make certain that the coupler pins are fully engaged. To check for full engagement, lower the attachment close to the ground, push the tilt control lever into the dump position until the attachment touches the ground. Then exert some down pressure on the attachment and bach up slowly. Observe that there is no movement between the coupler and the attachment. With the attached equipment lowered to the ground, shut off the machine and apply the parking brake. Visually inspect the coupler pins for full engagement. 12.16.1 COUPLING THE ATTACHMENT 1.
Push and hold coupler switch (1) in the “UNLOCK” position. The momentary contact switch must be held down to keep the coupler plungers fully retracted. At the same time, push the tilt lever (2) into the dump position and roll the coupler forward to align it with the attachment hooks. 2. Continue to hold the coupler switch in the “UNLOCKED” position. Drive the machine forward slowly to align the attachment hooks with the coupler tube. Pull the lift lever back slowly to raise the coupler. 3. Continue to hold the coupler switch in the “UNLOCKED” position. Raise the coupler until its tube engages the attachment hooks and the attachment is lifted off the ground slightly.
Observe that the attachment is level, and the hooks are engaged properly. 4. Continue to hold the coupler switch in the “UNLOCKED” position. Tilt back the coupler with the attachment until the attachment pin holes are aligned with the coupler plungers. Hold the tilt lever in the full tilt back position to allow full system pressure to fully extend the coupler plungers. 2-58