Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

2.3 FUEL INJECTOR LINE NOTICE: Do not crimp or nick the injector line tubing. Overbending the tubing can close the passage or restrict the flow of fuel. Nicks can cause weak spots that could lead to injector line failure. PERSONAL INJURY To avoid injury from the sudden release of a high-pressure hose connection, wear a face shield or goggles. 5. Carefully remove the injector line from the engine. 2.3.2 Fuel Injector Line Installation Install the fuel injector line as follows: NOTICE: New injector lines are supplied ready for installation. If the flared cone ends of the line do not line up with the transfer-tube and unit-pump fittings, carefully bend the line by hand for a proper fit.

Never use pliers or sharp-edged tools to bend injector lines. Doing so could damage them. Injector lines should fit without tension over the transfer-tube and unit-pump fittings. NOTE: A torque wrench is designed to a apply a specified torque directly on the fastener. When using a torque wrench with an adaptor, the final torque on the fastener will be greater than the number you set on the wrench itself. 1. Before installing the injector line, tighten the thrust bolt, using the thrust bolt torque wrench adaptor, (J 45063). The final torque on the bolt must be 45 N·m (33 lb·ft ). [a] Attach the adaptor to the torque wrench drive.

[b] The amount of torque you need to apply depends on the length of your torque wrench. Examples: For a 12-inch torque wrench, tighten 40 N·m (30 lb·ft). For a 24-inch torque wrench, tighten 36 N·m (27 lb·ft). 2. Install the injector line nuts finger-tight at both ends. 3. Using the injector line torque wrench adaptor, (J 45062), tighten the injector line nuts at the transfer tube and at the unit pump. The final torque on the bolt must be 30 N·m (22 lb·ft). All information subject to change without notice. 2-16 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION