Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

2.4 FUEL INJECTOR NOZZLE 7. Attach the impact extractor (355 589 01 63 00) and adaptor (904 589 00 63 00). Thread the narrow end of the adaptor onto the internal M8 threading in the head of the nozzle. Thread the impact extractor onto the wide end of the adaptor. See Figure 2-11. 1. Nozzle 4. End Cover 2. O-ring 3. Seal Ring Figure 2-11 Pulling the Nozzle NOTE: Do not attempt to take apart the nozzle. If there is a problem, replace the nozzle. 8. Using the impact extractor (355 589 01 63 00), remove the nozzle from the cylinder head. Discard the O-ring and the seal ring. NOTICE: Pull the nozzle straight out of the cylinder head. Do not twist it, turn it, or use pliers.

This could damage the nozzle. 9. Remove the impact extractor (355 589 01 63 00) and adaptor (904 589 00 63 00) from the nozzle. 10. Cap off or cover the openings in the fuel lines to prevent contamination of the fuel. 2.4.2 Fuel Injector Nozzle Installation Install the fuel injector nozzle as follows: All information subject to change without notice. 2-20 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION