MBE 4000 SERVICE MANUAL 1. Using a dial caliper, measure the length of the M10 retaining bolt from the end of the bolt to the bottom of the flange. See Figure 2-12. The acceptable lengths are listed in Table 2-1. Replace any bolt which does not meet these specifications. 1. Dial Caliper 3. Bottom of Flange 2. End of Retaining Bolt Figure 2-12 Measuring the Retaining Bolt Table 2-1 M10 Retaining Bolt, Length 2. Lubricate a new nozzle O-ring with a light coating of engine oil and install it on the nozzle. 3. Install a new seal ring on the nozzle. NOTE: Take care that the nozzle is installed correctly and is aligned properly with respect to the transfer tube.
All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 2-21 Description Length, mm (in.) Shaft length when new 90.0 mm (3.54 inches) Maximum shaft length 91.0 mm (3.58 inches)