MBE 4000 SERVICE MANUAL 6. Lubricate a new transfer-tube O-ring with a light coating of engine oil and install it on the transfer tube. NOTE: Do not tighten the thrust bolt until after the tensioning arm has been fully tightened to the correct torque value. 7. Install the transfer tube in the cylinder head. Tighten the thrust bolt 45 N·m (33 lb·ft). 8. Install the injector line. Refer to section 2.3.2. 9. Install the charge-air manifold. Refer to section 6.1.2. 10. Install the cylinder head cover(s), as removed. Refer to section 1.1.2. 11. Install the engine trim cover. All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 2-23