Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

MBE 4000 SERVICE MANUAL 3.3 EGR CAMSHAFT LUBRICATION SPRAYER The EPA 98 (non-EGR) engine has one oil passage drilling hole on a lube sprayer – it is used on the injector unit pump. The lube sprayer for the EPA 04 (EGR) engine has three oil passage drilling holes – they are used on the injector unit pump, intake cam follower and exhaust cam follower. See Figure 3-10. 1. Oil Passages Figure 3-10 EGR Camshaft Lubrication Sprayer 3.3.1 EGR Camshaft Lubrication Sprayer Removal Remove the EGR camshaft lubrication sprayer as follows: 1. Remove the injector unit pump lubricator bolt holding the sprayer in place. 2. Remove the sprayer. 3. Clean any clogged holes with solvent.

3.3.2 EGR Camshaft Lubrication Sprayer Installation Install the EGR camshaft lubrication sprayer as follows: 1. Install the lubrication sprayer to block with injector unit pump lubricator bolt. 2. Torque bolt to 20 N·m (15 lb·ft). All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 3-13