MBE 4000 SERVICE MANUAL 8. Remove the two bolts mounting the lower coolant inlet pipe to the block and remove the bracket bolt, just below the membrane, which attaches the lower coolant inlet pipe to the block. Remove gasket. See Figure 7-21. 1. Lower Coolant Inlet Pipe 4. Shut off Valve Housing Bolt (2 qty.) 2. Membrane 4. Air Supply Line 3. Air Line Mounting Bolts Figure 7-21 Removing Coolant Inlet Pipe 9. Pull down on the lower coolant inlet pipe to loosen it from the upper pipe. Remove the membrane also. NOTE: Have a container nearby to drain any unused coolant from the inlet pipes. 10. Remove the two shut off valve housing bolts that hold the valve housing to the EGR cooler support.
See Figure 7-21. 11. Remove the air line mounting bolts. Loosen and remove the air supply line from the EGR shut off valve. See Figure 7-21. All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 7-29