7.4 EGR COOLER AND COOLER SUPPORT BRACKET 2. Install the cooler support to the cylinder heads using the eight mounting bolts. Torque all bolts to 25 N·m (19 lb·ft). See Figure 7-28. 1. M10 x 65 mm bolts 2. M10 x 45 mm bolts Figure 7-28 Installing EGR Cooler Support NOTE: If at this point the exhaust manifold gasket studs are still in place, they will need to be removed. NOTE: Assemble and attach the EGR reed valve housing to the cooler before mounting the cooler to the cooler support. 3. Insert the reed valves into the EGR reed valve housing flange. All information subject to change without notice. 7-36 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION