Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

7.4 EGR COOLER AND COOLER SUPPORT BRACKET 6. Using industrial petroleum grease, insert a membrane into the side of the EGR control valve that is closest to the EGR cooler. See Figure 7-30. 1. Symmetric membrane 2. EGR Temperature Sensor Figure 7-30 Installing Symmetric Membrane into EGR Valve 7. Lift entire EGR cooler with attached cooler flange and sit this on top of cooler support, taking care to insert the upper half of the coolant inlet pipe down through the appropriate hole in the cooler support. At the same time, push the cooler flange into the membrane. See Figure 7-30. NOTE:

The oil filter and oil filter cover should be removed for good clearance when removing and installing the EGR cooler assembly. All information subject to change without notice. 7-38 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION