Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

7.6 EPV (ELECTRONIC PROPORTIONAL VALVE) AND WABCO ® AIR SOLENOID VALVE PERSONAL INJURY To avoid injury from the sudden release of a high-pressure hose connection, wear a face shield or goggles. 2. Disconnect the compressed air pipe between inlet connection installed at EPV valve and turbo brake actuator. See Figure 7-42. 1. EPV (Electronic Proportional Valve) 6. Large Hollow Screw 2. Wastegate 7. Small Hollow Screw 3. Electric Wiring Harness Terminals 8. EPV Valve Inlet 4. Wabco Valve 9. EPV Valve Outlet (hidden) 5. Solenoid Valve Mounting Bolts 10. EPV Valve Mounting Bolts Figure 7-42 Installing the EPV Valve / Wabco Solenoid Valve 3.

Remove the smaller hollow screw below the larger hollow screw. 4. Disconnect the inlet and outlet connections at EPV pressure regulating valve. 5. Remove the large hollow screw in threaded connection. 6. Remove the two M8 x 50 mm bolts that hold the EPV valve on the left side of bracket. 7. Remove the two M8 x 50 mm bolts that hold the Wabco solenoid valve on the right side of bracket. All information subject to change without notice. 7-52 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION