MBE 4000 SERVICE MANUAL 1. Disconnect the batteries. 2. Release the tension on the A/C compressor drive belt. See Figure 8-1. [a] Place a socket wrench on the tensioner pulley bolt. [b] Pull the socket wrench (swivel the tensioner pulley clockwise) to remove the tension from the belt. [c] Hold the tensioner pulley in this position for the next step. 3. Remove the drive belt from the A/C compressor pulley. Be careful not to kink, stretch, or otherwise damage the belt. See Figure 8-6. 1. Crankshaft Pulley 3. A/C Compressor Belt 2. A/C Compressor Belt Tensioner 4. A/C Compressor Pulley Figure 8-6 Air Conditioner Compressor Belt Removal 4. Release the tensioner pulley. 5.
Inspect the A/C compressor belt for nicks, wear, or other damage. Replace the belt if necessary. 6. Inspect the following parts and replace any that are damaged or worn: vibration damper A/C compressor pulley belt tensioner tensioner pulley idler pulley All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 8-9