Komatsu — IN COLD AREAS (AUTOMATIC WARMING-UP OPERATION)

OPERATION MACHINE OPERATIONS AND CONTROLS IN COLD AREAS (AUTOMATIC WARMING-UP OPERATION) When starting the engine in cold areas,carry out the automatic warming-up operation after starting the engine. When the engine is started,if the engine water temperature is low (below 30°C (86°F)),the warming-up operation is carried out automatically. The automatic warming-up operation is canceled if the engine water temperature reaches the specified tempera- ture (30°C (86°F))or if the warming-up operation is continued for 10 minutes.If the engine water temperature or hydraulic oil temperature are low after the automatic warming-up operation,warm the engine up further as follows.

NOTICE Never carry out operations or operate the levers sud- denly when the hydraulic oil is still at low temperature. Always continue the warming-up operation until the work equipment monitor display is green. This will extend the service life of the machine. Do not suddenly accelerate the engine before the warming-up operation is completed. Do not run the engine at low idling or high idling con- tinuously for more than 20 minutes.This will cause leakage of oil from the turbocharger oil supply pip- ing.If it is necessary to run the engine at idling,apply a load from time to time or run the engine at a mid-range speed.

REMARK If the hydraulic oil temperature is low, the hydraulic oil temperature monitor display will be white. 1. Turn fuel control dial (2) to the medium speed position. 2. Set safety lock lever (1) to the FREE position and raise the bucket from the ground. 3-77