Komatsu — CLEAN INSIDE OF COOLING SYSTEM

MAINTENANCE MAINTENANCE PROCEDURE Mixing rate of water and antifreeze PC200 PC220 WARNING Antifreeze is flammable, so keep it away from flame. Antifreeze is toxic. When removing the drain plug, be careful not to get water containing antifreeze on you. I If it gets in your eyes, flush your eyes with large quantities of fresh water and see a doctor at once. Use city water for the cooling water. If river water, well water or other such water supply must be used, contact your Komatsu distributor. We recommend use of an antifreeze density gauge to control the mixing proportions. Prepare a container to catch drained coolant: Min 21.5 liters (5.68 US gal) capacity. Prepare a hose to supply water.

1. Turn radiator cap (1) slowly and remove it. 2. Remove the undercover, then set the container under drain valve (2) to catch the coolant mixture. Open drain valve (2) at the bottom of the radiator and drain the coolant. 3. After draining the coolant, close drain valve (2), and fill with city water. When the radiator is full, start the engine and run at low idling to raise the temperature to at least 90°C, then continue to run for approx. 10 minutes. 4-27 Min. atmospheric temperature °C -10 -15 -20 -25 -30 °F 14 5 -4 -13 -22 Amount of antifreeze liters 6.9 8.2 9.3 10.5 11.4 US gal 1.82 2.17 2.46 2.77 3.01 Amount of water liters 15.9 14.6 13.5 12.3 11.4 US gal 4.20 3.86 3.57 3.25 3.01 Min.

atmospheric temperature °C -10 -15 -20 -25 -30 °F 14 5 -4 -13 -22 Amount of antifreeze liters 9.3 11.1 12.7 14.2 15.4 US gal 2.46 2.93 3.36 3.75 4.07 Amount of water liters 21.6 19.8 18.2 16.7 15.5 US gal 5.71 5.23 4.81 4.41 4.10