DISASSEMBLY AND ASSEMBLY RECOIL SPRING 12 RECOIL SPRING Disassembly 1. Remove piston assembly (2) from recoil spring assembly (1). 2. Disassembly of recoil spring assembly A. Set recoil spring assembly (1) to tool H1 . WARNING! The recoil spring is under large installed load, so be sure to set the tool properly. Failure to do this is dangerous. # Installed load of spring: PC200, PC220: . . . . . . . . . . . . . . . . . . . . . . . .139.3 kN (19,200 kg) B. Apply hydraulic pressure slowly to compress spring, and remove lock plate (3), then remove nut (4). # Compress the spring to a point where the nut becomes loose. # Release the hydraulic pressure slowly and release the tension of the spring.
# Free length of spring: PC200, PC220: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 603.5 mm C. Remove yoke (6), plate (15), cylinder (7), and dust seal (8) from spring (5). 3. Disassembly of piston assembly A. Remove lock plate (10) from piston (9), then remove valve (11). B. Remove snap ring (12), then remove U-packing (13) and ring (14). PC200-6LL/PC220LL-6 30-3