DISASSEMBLY AND ASSEMBLY RECOIL SPRING 12 Assembly 1. Assembly of piston assembly A. Assemble ring (14) and U-packing (13) to piston (9), and secure with snap ring (12). B. Tighten valve (11) temporarily, and secure with lock plate (10). 2. Assembly of recoil spring assembly A. Using tool H2 , install dust seal (8) to cylinder (7). B. Assemble cylinder (7), plate (15), and yoke (6) to spring (5), and set in tool H1 . Sliding portion of cylinder: . . . . . . . . . . . . . Grease (G2-L1) C. Apply hydraulic pressure slowly to compress spring, and tighten nut (4) so that installed length of spring is dimension " a ", then secure with lock plate (3). # Installed length " a " of spring:
PC200, PC220:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 452 mm D. Remove recoil spring assembly (1) from tool H1 . 3. Assemble piston assembly (2) to recoil spring assembly (1). Sliding portion of piston, wear ring: . . . . . . Grease (G2-L1) # Assemble the cylinder assembly so that the mounting position of the valve is 90° to the side. # Fill the inside of the cylinder with 300 cc of grease (G2-L1) , then bleed air and check that grease comes out of the grease hole. 30-4 PC200-6LL/PC220LL-6