3. Apply sealer to the outside of the rod seal. Install the seal in the end of the rod bore. See Figure 4-346. 6. Apply Loctite to the shift fork bolts. Install the bolts and tighten to 35 Nm (26 ft lb). See Figure 4-349. FIGURE 4-346 4784 FIGURE 4-349 4787 4. Apply sealer and install the seal in the other end of the rod bore. See Figure 4-347. 7. Install the sleeve fingers into the shift fork. Install the synchromesh sleeve and thrust washer. See Figure 4-350. FIGURE 4-347 4785 FIGURE 4-350 4788 5. Set the shift fork into the housing and slide the shift rod into the shift fork. See Figure 4-348. Align the bolt holes in the shift rod with the bolt holes in the shift fork. 8.
Install the disc and then the ball bearing. See Figure 4-351. FIGURE 4-348 4786 FIGURE 4-351 4789 4-84 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual