9. Install the snap ring. See Figure 4-352. 12. Install the lock screw. See Figure 4-355. FIGURE 4-352 4790 FIGURE 4-355 4793 10. Use a bearing driver to install the drive flange seal. See Figure 4-353. The top of the seal housing should be 12.0 mm (.472") from the top of the housing bore. Coat the inside lips of the seal with grease. 13. The dowel and bolt that were installed in Steps 1 and 2 must be adjusted to create an over- shift travel of .10 – .20 mm (.0039 – .0078") during engagement or disengagement. See Figure 4-356. The shim between the bolt and dowel can also be changed if necessary. Install the shift lever. FIGURE 4-353 4791 11. Turn the housing over. Insert the shaft.
See Figure 4-354. FIGURE 4-356 4794 14. Install the drive flange on the shaft spline. See Figure 4-357. FIGURE 4-354 4792 FIGURE 4-357 4795 Mega 300-III Shop Manual TORQUE CONVERTER AND TRANSMISSION 4-85