daewoo — Daewoo Wheel Loader Shop Manual

17. Push the neutral position springs out of the groove in the spool. See Figure 5-26. FIGURE 5-28 4957 FIGURE 5-26 4955 Assembly Use the bolt torque chart that follows to tighten the bolts as the steering unit is assembled. 18. Remove the dust seal from the housing. See Figure 5-27. Remove the O-ring and backup ring from inside the housing. 1. Install the springs in the spool slot. See Figure 5-29. The springs must be positioned as shown in Figure 5-30. FIGURE 5-27 4956 19. Figure 5-28 shows all the parts removed from the steering unit. Clean all parts before assembly. Use only new O-rings and seals.

FIGURE 5-29 4958 MEGA 300-III Shop Manual POWER STEERING 5-11 Bolt Torque Chart Bolt Size Torque Value M10 4.8 kg m (35 ft lb) 3/8 – 16 NC 4.8 kg m (35 ft lb)