FIGURE 5-30 4959 2. Position the springs so that the amount of spring protruding out of the spool is equal on both sides. See Figure 5-31. FIGURE 5-33 4960 4. Center the springs in the sleeve. See Figure 5-34. FIGURE 5-31 4961 3. Insert the spool into the sleeve. See Figure 5-32. Use care so that the sleeve and spool are correctly assembled. The spring slot in the sleeve must align with the spring slot in the spool. Also, one of the T shaped slots (A) in the spool must align with one of the small FIGURE 5-34 4963 5. Install the seal ring on the sleeve. See Figure 5-35. Burnish the seal ring with a smooth object until the seal does not protrude past the diameter of the sleeve.
FIGURE 5-32 4962 holes (B) in the sleeve. See Figure 5-33. FIGURE 5-35 4964 5-12 POWER STEERING MEGA 300-III Shop Manual