6. Rotate the seal ring. See Figure 5-36. It must FIGURE 5-38 4967 FIGURE 5-36 4965 rotate freely without resistance. 1. Thrust Washer 2. Thrust Bearing 3. Thrust Washer 4. Spool 5. Sleeve FIGURE 5-37 4966 FIGURE 5-39 4968 7. Turn the sleeve 180°. Install the cross pin into the sleeve and spool. See Figure 5-37. 9. Oil the O-ring and backup ring and then install them on an O-ring assembly tool. See Figure 5-40. 8. Install the 2 thrust washers and the thrust bearing over the end of the spool. See Figure 5-38. The sequence of the parts installation is shown in Figure 5-39. FIGURE 5-40 4969 MEGA 300-III Shop Manual POWER STEERING 5-13