20. Install the distributor plate. See Figure 5-51. Be sure to properly align the plate holes with the holes in the middle plate. FIGURE 5-53 4982 23. Lubricate 2 O-rings with 20 weight mineral oil and install them in the grooves of the cylinder gear. Slide the cylinder gear into position on the housing. See Figure 5-54. FIGURE 5-51 4980 21. Install the shaft into the bore of the housing. See Figure 5-52. Position the slot in the shaft to engage the cross pin. FIGURE 5-54 4983 FIGURE 5-52 4981 24. Use a bolt to align the bolt holes in the cylinder gear with the bolt holes in the housing. See Figure 5-55. 22.
Position the rotor so that the cross pin is located between 2 teeth as shown by the position of the screwdriver. See Figure 5-53. FIGURE 5-55 4984 5-16 POWER STEERING MEGA 300-III Shop Manual