30. Turn the steering unit over and work from the opposite side. Set the dust seal in position on the housing. See Figure 5-61. FIGURE 5-63 4992 33. Figure 5-64 shows the port identification for the steering unit. FIGURE 5-61 4990 31. Use a seal driver and a plastic hammer to install the dust seal. See Figure 5-62. FIGURE 5-64 4993 L = Left pressure port R = Right pressure port T = Tank port P = Pressure from pump FIGURE 5-62 4991 32. Install plastic plugs to prevent dirt from entering the steering unit. See Figure 5-63. The following table shows the torque specifications for the hydraulic fittings used to install the steering unit.
5-18 POWER STEERING MEGA 300-III Shop Manual Type of Screw Fitting Maximum Tightening Torque kg m (ft lb) 1/4 RG 1/4 BSP.F R 1/4 G 1/4 1/2 RG 1/2 BSP.F R 1/2 G 1/2 7/16-20UNF Cutting Edge 4 (29) 10 (72) Copper Washer 2 (15) 3 (22) Aluminum Washer 3 (22) 8 (58) O-ring 2 (15)