12. Remove the pump cartridge. See Figure 7-19. Match mark the major cartridge assemblies so that they can be returned to their original posi- tions during assembly. 14. Remove the wear plate (26, Figure 7-21). Remove the cam ring (28). 26. Wear Plate 28. Cam Ring Remove the bolts (24, Figure 7-19) that retain the pressure plate (23). Remove the pressure plate. 23. Pressure Plate 24. Bolts FIGURE 7-21 4053 15. Wind a rubber band around the rotor to prevent the vanes from falling out of their slots. Remove the rotor from the wear plate. Mark down the slot that each vane was removed from. During assembly, this will make it possible to return each vane to the slot that it was removed from.
Remove the vanes from the rotor. FIGURE 7-19 4051 13. Remove the seal (25, Figure 7-20) from the pressure plate. 25. Seal 16. Remove the wear plate (29, Figure 7-22). Remove the seal from the pressure plate (30). 29. Wear Plate 30. Pressure Plate FIGURE 7-20 4052 FIGURE 7-22 4054 7-8 HYDRAULIC SYSTEM Mega 300-III Shop Manual