Engine Oil Pump Overhaul and Rebuilding 1. Drain all oil from the oil pan and remove the pan to allow access to the oil pump. 2. Unbolt the two 10 mm x 50 mm fasteners holding the pump to the bottom of the engine block and remove the pump for service. IMPORTANT 3. Remove the plug and locknut holding the oil relief valve to the lower part of the pump body. Before withdrawing the valve from the body of the pump, Before removing or disassembling the pump, consider the following causes of low oil pressure and eliminate the possibility that a simpler procedure could provide a repair: Wrong, worn or very low oil. Relief valve stuck open. Oil pump feed pipe cracked, broken or leaking.
Oil pump strainer clogged. Oil pressure gauge inaccurate. Oil pump gears or other components worn or defective. Crankshaft or connecting rod bearings worn. A. Undo the front lock ring and attaching nut on the pump drive gear and use a gear puller or two screwdrivers to remove the pump drive gear, which is held with a woodruff key. See Figure 8-2. 1. Lock Ring 2. Pump Cover 3. Woodruff Key 4. Dowel Pins 5. Relief Valve Plunger FIGURE 8-1 0259 Mega 300-III Shop Manual ENGINE 8-7