FIGURE 8-2 0260 B. Unbolt the oil pump cover and carefully pull it away from the body of the pump, taking care not to bend or otherwise damage the dowel pins maintaining alignment position of the cover. FIGURE 8-4 0262 Allowable clearance between the pump (output) drive shaft and pump cover hole is between 0.032 mm (0.0013") and 0.077 mm (0.0030"). 4. With both gears still in the housing, use a straight edge and feeler gauge to measure the gap between the outer face of the gears and the pump cover. See Figure 8-3. Allowable clearance is between 0.025 mm (0.001") and 0.089 mm (0.0035"). Replace the cover or gear(s) if clearance is exceeded.
Allowable clearance between the pump driven shaft (input) and the pump cover hole is between 0.040 mm (0.0016") and 0.094 mm (0.0037"). Replace the pump cover or one or both gears if values are beyond specified limits. 8. Pump reassembly consists of reversing the steps of the disassembly procedure. IMPORTANT Make sure that all parts have been thoroughly cleaned of all traces of grit, dust or sediment before reassembly. Always pre- lubricate friction surfaces of moving parts with engine assembly lube, to reduce any chance of causing damage upon initial start-up. FIGURE 8-3 0261 5. Measure gear backlash as shown with a feeler gauge. See Figure 8-4.
The allowable value is between 0.50 mm (0.020") and 0.65 mm (0.026"). 6. Remove the gears from the pump body and check the diameter of both gear shafts with a micrometer. The standard tolerance is 16.968 mm (0.6680") to 16.950 mm (0.6673"). 7. The final dimensional checks that need to be made are for the diameter and eccentricity of the shaft holes in the cover. Use a bore gauge to measure shaft hole diameter across several points, to make sure the hole is not out-of-round. Subtract measured shaft diameter from the measured bore dimension. 8-8 ENGINE Mega 300-III Shop Manual