Fuel Injection Pump Installation, Alignment and Timing Injection Pump Installation The bracket can be shimmed closer to or farther away from the engine block with four available sizes of flat shims, for shimming vertical clearance to the block: If the fuel injection pump must be removed from the engine for overhaul, repair or replacement, it will be necessary to shim the pump mounting bracket as part of the installation procedure. See Figure 8-5. Precise, accurate positioning of the mounting bracket in relation to the cylinder block is required in order to set up and correctly align the pump and pump coupling drive shaft.
0.1 mm (0.004") 0.15 mm (0.006") 0.2 mm (0.008") 0.5 mm (0.020") There are three available sizes of washer shims, for adjusting pump height, to change the horizontal alignment of the pump: Smooth and efficient operation of the engine requires that a correctly metered volume of fuel is injected into the engine cylinder, at precisely the right instant, in response to variable load and speed requirements. Both the volume of fuel and the timing of fuel delivery, in relation to engine rotation, are adjustable. After the pump and mounting bracket have been correctly positioned check injection timing and delivery volume. 0.1 mm (0.004") 0.2 mm (0.008") 0.3 mm (0.012") 1.
Shims FIGURE 8-5 0263 Mega 300-III Shop Manual ENGINE 8-9