Injection delivery for the number 1 cylinder should be timed to 5.6° BTDC with the plunger in the pump stopping fuel flow as the plunger is lifted to: IMPORTANT 3.0 mm (± 0.5 mm), or Prior adjustment of engine timing gears (idler gear and injection pump drive gear) may be necessary for injection pump re- installation and alignment. 0.118" (± 0.002"). If a change in the adjustment position is required, make the necessary correction by changing shim thickness between the flange sleeve and pump housing. See Figure 8-6. NOTE Gear backlash between all timing gears should be between 0.16 mm (0.006") and 0.28 mm (0.011").
Injection Pump Delivery Volume Test injection volume using correct injection nozzles, nozzle holders and injection pipes. Tested fuel should be at a relatively warm temperature, between 40°C – 45°C (105°F –115°F). When pump mounting bracket shims have been installed in place, position the pump on the bracket and fully tighten installation bolts. Rotate the engine until the mark on the vibration damper (at the front of the engine) is aligned with the pointer on the block. Remove the rectangular cover from the top of the flywheel housing in order to check alignment position. Keep delivery pressure adjusted to 1.6 kg/cm 2 (23 psi).
To adjust injection volume, loosen the 2 nuts on the flange sleeve (12, Figure 8-6) and turn the flange sleeve (together with the plunger barrel) by using the long hole in the sleeve. Turn the flange sleeve clockwise to increase injection volume and counterclockwise to reduce volume. Align the pointer on the injection pump with the line on the timer and assemble the injection pump and coupling drive shaft. If alignment is incorrect, unbolt the injection pump mounting bracket, remove or add shims as required, and reinstall the pump. When alignment between the pump and coupling drive shaft is correct, use two open end wrenches to tighten the coupling joint bolts, simultaneously. 1. Nut 2.
Washer 3. O-ring 4. Deflector 5. O-ring 6. Camshaft 7. Cover 8. Delivery Valve Holder 9. Delivery Valve Gasket 10. Adjusting Shim 11. Delivery Valve 12. Flange Sleeve 13. Plunger Barrel 14. Plunger 15. Control Rod 16. Control Sleeve 17. Tappet Injection Pump Timing Check Turn the engine manually until the number 1 cylinder is at TDC. Remove the delivery valve holder for number 1 cylinder from the top of the pump, along with the delivery valve spring, delivery valve and delivery valve gasket. Install a tester (dial-type plunger stroke indicator or a glass tube volume level indicator) in the number 1 cylinder pump hole and observe tester manufac- turer’s set-up instructions.
For most types of injection pump testers, it’s neces- sary to “zero” the tester by rotating the pump plunger to bottom dead center. Turn the pump manually and adjust the tester. With number 1 cylinder at bottom dead center and the tester set up to measure plunger stroke (dial- type) or delivery volume (glass tube-type) turn the engine slowly by hand, bringing it up towards the number 1 cylinder top dead center position. FIGURE 8-6 0264 8-10 ENGINE Mega 300-III Shop Manual