daewoo — Daewoo Wheel Loader Shop Manual

Cylinder Head Bolt Torque Requirements NOTE The standard value for cylinder head height is 114.9 mm – 115.0 mm (4.524" – 4.528"). Service limit replacement value is 113.9 mm (4.484"), or less. There are two separate sections of the cylinder head. Each half of the head is mated to three individual cylinders in the engine block. During engine reassembly following an overhaul or repair, or at regular, periodic maintenance intervals (every 2,000 operating hours) checking head bolt fastener torque is a recommended service precaution. Cylinder Head Tightening Procedure One cylinder head section is shown in the illustration. See Figure 8-8.

The tightening sequence for head bolt fasteners is indicated by the number next to each of the head bolts. Cylinder Head Surface Flatness 1. If the engine has been disassembled for service or repair, it is important to carefully clean carbon and deposits from the block and manifold mating surfaces of the cylinder head. 1. Clean each head bolt and the mating threads inside the engine block before reassembly. 2. The upper face of the cylinder block should be thoroughly cleaned and checked for distortion (maximum limit, 0.05 mm [0.002"]). 3. Use mating dowels to align the head gasket and cylinder head assembly to the engine block. 2.

Check for distortion of the cylinder head prior to reassembly, using a straight edge and feeler gauge. Measure across six pairs of coordinates along the plane of each mating surface (block and manifold). See Figure 8-7. 4. Pre-lubricate head bolts with clean engine oil and begin at head bolt number 1. Torque that bolt to 15 kg m (108 ft lb). Tighten each bolt in succession to the same value, then repeat the sequence, tightening to 20 kg m (145 ft lb). Repeat the procedure once again, tightening to the final head bolt torque value, 24.5 kg m (177 ft lb). FIGURE 8-7 0265 3.

If measured clearance between the straight edge and head exceeds 0.2 mm (0.008") at any point along the length of lines 1 through 6 , repair the damage with a surface grinder prior to reassembly. See Figure 8-7. If measured distortion exceeds 0.3 mm (0.012"), replacement of the cylinder head is required. (Required service value for the manifold surface is 0.4 mm (0.016"), and the service limit recommended replacement value is 1.0 mm (0.040"). FIGURE 8-8 0266 Mega 300-III Shop Manual ENGINE 8-11