daewoo — Daewoo Wheel Loader Shop Manual

Inspect the tubes and clamps that are attached to the air cleaner. Be certain that the tubes have no holes, and that the clamps are tight. Every 500 Operating Hours The engine is equipped with a pre-cleaner. See Figure 3-28. Dust, insects, rainwater etc., can be present in the air. The pre-cleaner collects this material and discharges it. This prevents the mate- rial from being drawn into the air cleaner. The pre-cleaner does not need periodic cleaning or replacement. Perform All 10, 50, and 250 Hour Service Checks Fuel Filter Element Replacement There are two fuel filters, a primary and a secondary. See Figure 3-18. Perform the following procedure on each filter. 1.

Remove the bolt from the bottom of the element cover. 1. Rotor 2. Dust Particle Discharging Port 2. Remove the element, cover, and O-ring from the filter head. 3. Install a new element and O-ring. 4. Set the cover into place in the filter head. 5. Insert the bolt through the bottom of the element cover. Tighten the bolt. Every 1,000 Operating Hours Figure 3-28 2840 Perform All 10, 50, 250, and 500 Hour Service Checks Change Engine Oil and Filter Follow procedure printed under 50 hour mainte- nance interval. Center Axle and Axle End Oil Check The oil level in both the front and rear axle must be checked every 1,000 hours. The oil in both axles must be replaced every 1,500 hours.

Replace Transmission Oil Filter Follow procedure printed under 50 hour mainte- nance interval. Each axle contains a center differential, and a differential in each axle end. The same oil lubri- cates the center differential and the differentials in the axle ends, but the oil flows very slowly between these points. Therefore, the oil must be checked and refilled at all three places at the same time. To check the oil level, perform the following steps. Hydraulic Full Flow Filter Replacement Follow procedure printed under 50 hour mainte- nance interval. 1. Drive the machine onto a level surface.

Position the wheels on the axle being checked so that the axle end level plugs (1, Figure 3-29) are in the lowest position. Apply the parking brake. Block the wheels. MEGA 300-III Shop Manual INSPECTION, MAINTENANCE AND ADJUSTMENT 3-13