daewoo — Daewoo Wheel Loader Shop Manual

Drain and Replace Hydraulic Oil CAUTION!!! Be certain that the hydraulic oil has cooled before draining it. Hot oil could splash and cause burns. FIGURE 3-29 1. Raise the boom to its highest position. Tilt the bucket back as far as possible, and turn off the engine. See Figure 3-31. 2. Clean the area around the level plugs on both ends of the axle. Remove the plugs. 3. Clean the area around the level plug (1, Figure 3-30) on the center differential. Remove the level plug (1). 1. Level Plug 2. Drain Plug FIGURE 3-31 2052 NOTE The hydraulic reservoir contains 250 l (264 qt) of oil. 2. Position a catch tank beneath the hydraulic reservoir drain plug. Open the reservoir breather cap.

See Figure 3-15. Remove the drain plug from the bottom of the reservoir. See Figure 3- 32. Allow all hydraulic oil to drain out. FIGURE 3-30 4. Check the oil level at the level plug hole on the center differential and the axle end differ- entials. The oil should be level with the bottom of the plug hole. Add oil as necessary. 5. Install the level plugs at all three locations. 6. Perform the previous five steps on the other axle. FIGURE 3-32 2053 Without starting the engine, operate the controls to dump the bucket. See Figure 3-33. Then operate the controls to lower the boom. See Figure 3-34. This will drain the oil out of the boom and bucket cylinders.

3-14 INSPECTION, MAINTENANCE AND ADJUSTMENT MEGA 300-III Shop Manual