daewoo — Daewoo Wheel Loader Shop Manual

5. Install the reservoir drain plug. Refill the reser- voir by pouring oil in through the breather cap opening. Install and tighten the breather cap. 6. Start the engine and operate the controls to raise and lower the bucket a few times. See Figure 3-35. Raise and lower the boom a few times. See Figure 3-36. Lower the bucket to the ground. FIGURE 3-33 2054 FIGURE 3-35 2057 FIGURE 3-34 2055 3. Replace the full flow hydraulic filters, as described in the 50 hour (weekly) mainte- nance checks. 4. Remove and clean the pump inlet strainer (7) that is located inside the hydraulic reservoir. See Figure 3-23. FIGURE 3-36 2058 A. Remove the bolts (8) that retain the strainer cover (9). 7.

Check the reservoir sight gauge. See Figure 3-14. The oil level must be between the upper limit and the lower limit on the sight gauge. Remove the breather cap and add oil if necessary. B. Remove the strainer cover (9) and the strainer (7) from the reservoir. C. Remove the strainer (7) from the strainer cover. Drain and Replace Transmission Fluid 1. Start the machine and drive it until the trans- mission fluid has warmed to 65 – 93°C (149 – 200°F). Park the machine on a level area. D. Clean the strainer (7) in a nonflammable, non toxic solvent. E. Mount the strainer (7) on the strainer cover (9). 2. Place the transmission lever in neutral. Apply the parking brake. Turn off the engine.

Block the tires. F. Insert the strainer (7), and cover (9), into the reservoir. G. Install and tighten the bolts (8) that retain the cover (9). MEGA 300-III Shop Manual INSPECTION, MAINTENANCE AND ADJUSTMENT 3-15