daewoo — Daewoo Wheel Loader Shop Manual

NOTE The transmission contains 28 l (29.6 qt) of trans- mission fluid. 1. Dipstick 3. Remove the drain plug (1, Figure 3-37). Allow all transmission fluid to drain into a receptacle. Properly dispose of the drained fluid. Clean the drain plug (1). 1. Drain Plug FIGURE 3-38 2867 9. Start the engine. Idle the engine for two minutes. 10. With the engine idling, check the transmission fluid level. Add fluid until the level reaches the high mark on the dipstick. 11. Idle the engine until the transmission fluid temperature reaches 82 – 93°C (180 – 200°F). Check the fluid level with the engine idling. The level must reach the high mark on the dipstick. FIGURE 3-37 2868 4.

Install the drain plug in the transmission. Clean Fuel Tank and Strainer 1. Drain the fuel tank. 5. Remove the inlet strainer. Use a nonflam- mable, non-toxic solvent to clean the strainer. 6. Inspect the gasket on the inlet strainer. Replace the gasket if it is damaged. Install the inlet strainer. 2. Remove the cover and strainer located on the bottom of the tank. 3. Use a nonflammable, non-toxic, parts cleaner to clean the strainer and any sediment inside the tank. 7. Remove the breather filter. Clean the breather filter and install it. 8. Fill the transmission with fluid through the fluid supply pipe. Add fluid until the fluid level reaches the low mark on the dipstick (1, Figure 3-38).

4. Install the strainer and cover. 3-16 INSPECTION, MAINTENANCE AND ADJUSTMENT MEGA 300-III Shop Manual