Replace Air Cleaner Element 1. Radiator Cap 2. Drain CAUTION!!! Never remove the air cleaner element while the engine is running. This will allow dirt to be sucked into the engine and cause serious engine damage. Always turn the engine off before servicing the air cleaner. 1. Loosen the clamp that holds the cover on the air cleaner housing. See Figure 3-27. 2. Remove the element from the air cleaner housing. 3. Install a new filter element. 4. Install the cover on the air cleaner. FIGURE 3-39 2843 Change Radiator Coolant 6. Start the engine and allow it to run until it reaches normal operating temperature. WARNING!!! 7. Allow the engine to cool. Check the coolant level in the radiator.
Add additional coolant as needed. Fill the radiator to a point that is 10 – 20 mm (1/2 – 3/4") below the top of the overflow pipe. Never open the radiator when it is hot. The scalding liquid inside a hot radiator is under pressure. Removing the cap from a hot radiator could cause a person to be sprayed and burned from the liquid inside. Wait for the radiator temperature to cool down before removing the cap. 1. Remove the cap (1, Figure 3-39) from the radiator. 2. Open the drain (2) at the bottom of the radi- ator. Allow all coolant to drain out. 3. If the coolant being drained is especially rusty, or especially dirty, use a radiator flush addi- tive.
Follow the directions on the container for the additive. 4. Completely flush the additive out of the cooling system with clean water. 5. Fill the radiator with clean water. If tempera- tures below freezing are expected, add enough ethylene glycol antifreeze to prevent the water in the cooling system from freezing. See Table 4-1 for the amount of antifreeze to add. MEGA 300-III Shop Manual INSPECTION, MAINTENANCE AND ADJUSTMENT 3-17