daewoo — Daewoo Wheel Loader Shop Manual

Every 1,500 Operating Hours Annually or Every 2,000 Operating Hours Perform All 10, 50, 250, and 500 Hour Service Checks Replace Hoses Replace the hoses that carry brake fluid to the wheel brakes. Also replace the hoses that carry hydraulic fluid to the steering cylinders. Center Axle and Axle End Oil Replacement Each axle contains a center differential, and a differential in each end. The same oil lubricates the center differential and the differentials in the axle ends, but the oil flows very slowly between these points. When checked, the oil must be checked and refilled at all three places at the same time. To drain and replace the oil in an axle, perform the following steps:

It is difficult to determine the condition of many hoses. The best way to ensure safe operation and to maintain maximum performance is to replace the hoses on a regular basis. If any of the brake or steering hoses become damaged or appear defec- tive in any way, replace them immediately regardless of the time interval since their last replacement. 1. Drive the machine onto a level surface. Position the wheels on the axle being drained so that the axle end level plugs (1, Figure 3-29) are in the lowest position. Apply the parking brake. Block the wheels. Bleeding Brakes When brake hoses or brake tubes are replaced, air can be introduced into the brake hydraulic system.

Air can cause the brakes to operate intermittently, which is a dangerous condition. Never operate the machine with air in the brake hydraulic system. A spongy feel when pressing the brake pedal is a sign that air is present in the brake hydraulic system. 2. Clean the area around the level plugs on both ends of the axle. Remove the plugs. NOTE The center differential in the front axle contains 32 l (33.8 qt) of oil. Each axle end differential in the front axle contains 10 l of oil. The drain container must have a capacity of at least 52 l (55 qt). To bleed air out of the brake hydraulic system, perform the following steps: The center differential in the rear axle contains 24 l of oil.

Each axle end differential in the rear axle contains 9 l of oil (9.5 qt). 1 Start the engine and place the transmission in neutral. 2. Remove the rubber cap from the bleeder screw on the wheel. See Figure 3-40. 3. Clean the area around the level plug (1, Figure 3-30) and the drain plug (2) on the center differential. Remove the level plug (1) and the drain plug (2). Allow the oil to drain into a container. 4. Install the drain plug into the center differen- tial, and tighten it. 5. Pump oil into the plug hole for the level plug on the center differential. Add oil until the oil level is even with the bottom of the plug hole. Go to the level plug holes on the axle ends.

Add oil to these openings until the oil level is even with the bottom of the plug hole. Recheck the level on the center differential. Add oil if necessary. When the oil level is satisfactory at all three level plug holes, install and tighten the level plugs at all three locations. 6. Perform the previous five steps on the other axle. FIGURE 3-40 2062 3-18 INSPECTION, MAINTENANCE AND ADJUSTMENT MEGA 300-III Shop Manual