3. Place one end of a plastic hose (1, Figure 3-41) over the bleeder screw (2). Place the other end of the hose in a container (3) filled with brake fluid. 1. Plastic Hose 2. Bleeder Screw 3. Container FIGURE 3-41 2063 4. Station one person in the operator’s cab, and one person at the bleeder screw on the wheel being bled. 5. Open the bleeder screw (2, Figure 3-41). Then press down on the brake pedal until it rests on the floor of the cab. Hold the pedal down on the floor of the cab. Close the bleeder screw while the pedal is being held down. After the bleeder screw has been closed, allow the brake pedal to return to the upright position.
Continue to open the bleeder screw and press down the pedal as described in this step, until the fluid expelled from the bleeder hose has no air bubbles present. 6. Securely close the bleeder screw (2). Install the rubber cap on the bleeder screw. 7. Perform the bleeding procedure on the other three wheels. MEGA 300-III Shop Manual INSPECTION, MAINTENANCE AND ADJUSTMENT 3-19