General Maintenance 1. Lock Nut 2. Brake Pad 3. Brake Disc Fuel Transfer Pump An optional fuel transfer pump (1, Figure 3-42) is available. This pump is mounted on top of the fuel tank (2). The switch that operates the pump is located to the inside of the left side battery box (when viewed from the counterweight (3) end of the machine). Place the pump inlet hose (4) into the refu- eling tank. Turn the pump switch on. Observe the fuel gauge inside the cab of the machine being fueled. When the tank is full, turn the pump switch off. 1. Transfer Pump 2. Fuel Tank 3. Counterweight 4. Inlet Hose 5. Radiator FIGURE 3-43 2061 4.
Check the clearance between the brake pad (2, Figure 3-43) and the brake disc (3). Clearance should be 1 – 2 mm (0.040 – 0.080"). 5. Rotate the adjusting rod to attain the specified clearance. 6. After the adjustment is complete, tighten the lock nut (1). Check Battery Condition WARNING!!! FIGURE 3-42 2844 Exercise caution when working around a lead-acid battery. These batteries contain sulfuric acid and give off hydrogen gas when they are charging. Sulfuric acid will cause serious damage to skin and eyes. Always wear eye protection when working on batteries. Hydrogen gas is explosive. Do not smoke, use open flame, or create sparks anywhere near the battery. The battery could explode.
Do not wear a watch or rings when working on the battery. These items could cause sparks. Do not allow a wrench to contact the posi- tive terminal of the battery any any other metal part of the machine at the same time. If the negative cable is connected to the battery, the wrench will create sparks. The transfer pump contains a fuel filter. When changing the filter, always fill the new filter with fuel before installing it. If the pump is operated without fuel inside the pump casing, the pump will be damaged. Parking Brake Adjustment To adjust the parking brake, perform the following steps. 1. Jack up the machine enough to allow the tires to rotate freely. 2.
Turn off engine and place transmission lever in neutral. Turn ignition switch to on position. Move the parking brake switch to the unlocked position. 3. Loosen the lock nut (1, Figure 3-43) on the adjusting rod. MEGA 300-III Shop Manual INSPECTION, MAINTENANCE AND ADJUSTMENT 3-21