2. Adjust pressure at cartridge C1. Pressure should be adjusted to 160 + 5 kg/cm 2 Transmission Clutch Pressure 1. Transmission pressure can be checked on the gauge in the operator’s cab. If this gauge is inoperative, attach a pressure gauge to the clutch pressure gauge port (1, Figure 3-51) on the transmission. (2,276 + 70 psi). 3. Loosen the locknut at the C1 adjusting screw. Turn the adjusting screw clockwise to raise the relief pressure. Turn the adjusting screw counterclockwise to lower the relief pressure. 4. Tighten the locknut after the adjustment has been made. 1. Gauge Port Service Brake Outlet Pressure 1. Attach the gauge to the outlet port of the brake pedal valve.
See Figure 3-50. 2. Outlet pressure should be 60 kg/cm 2 (853 psi). FIGURE 3-51 2852 2. With the transmission in neutral, and the engine at 2,000 – 2,530 RPM, the pressure should be 17 – 19 kg/cm 2 (272 – 270 psi). FIGURE 3-50 2851 3-24 INSPECTION, MAINTENANCE AND ADJUSTMENT MEGA 300-III Shop Manual