daewoo — Daewoo Wheel Loader Shop Manual

7. Turn the valve over and work from the oppo- site side. See Figure 4-11. Remove the snap ring (39) from bore “d.” Use a slide hammer (special tool) to pull piston (40) out of bore “d.” 10. Unscrew plug (46) from reverse gear valve block (47). Remove O-ring (48), spring (49), set screw (58) and spool (50). 11. Unscrew bolts (51, 52, 53, and 54) and remove valve block (47) and gasket (55). 12. Remove the spring (56) and check ball (57). Assembly NOTE Before permanently installing any of the valve spools, first lubricate all spool seals and parts. Then check to be sure that the spool moves freely in its bore. FIGURE 4-11 4450 1. Apply Loctite to the set screw (45) and install it.

See Figure 4-14. 8. Pull the stop plate (41) out of bore “d.” Remove the detent block (42), spool (43), and O-ring (44). See Figure 4-12. FIGURE 4-14 4453 2. Insert washer (35) into bore “e.” See Figure 4-15. Insert seal (36) into bore with seal lip facing into the valve. Insert washer (37) into bore. Install snap ring (38) into bore to hold parts in place. FIGURE 4-12 4451 9. Remove the snap ring (31) and (38) from bores “e” and “g.” See Figure 4-13. Remove washers (35 and 36) and (28 and 29). Remove spool shaft seals (30 and 37). FIGURE 4-15 4454 FIGURE 4-13 4452 Mega 300-III Shop Manual TORQUE CONVERTER AND TRANSMISSION 4-9