3. Insert washer (28) into bore “f.” See Figure 4-15. Insert seal (29) into bore with seal lip facing into the valve. Insert washer (30) into bore. Install snap ring (31) into bore to hold parts in place. 9. Insert spool (27) into bore “a.” See Figure 4-18. 4. Install ring (46) on spool (43). Insert spool (43) into bore “d.” Install detent block (42) and stop plate (41) into bore “d.” 5. Install ring (44) on piston (40). Install piston (40) into bore “d.” Install snap ring (39) into bore “d.” 6. Install spool (34) into bore “c.” See Figure 4-16. Install detent block (33) and stop plate (32). FIGURE 4-18 4457 10.
Install spring (25) and piston (26) into bore “b.” Spring length is 73.8 mm (2.9"). See Figure 4-18. 11. Install the spool (24), stop washer (23), and spring (22) into valve bore “c.” See Figure 4-18. Spring length is 46.6 mm (1.83"). Washer thickness helps determine control pressure. Control pressure is marked on transmission identification plate. FIGURE 4-16 4455 Washer ZF number 0730 103 356 has 2.0 mm (.078") thickness Washer ZF number 0730 103 835 has 3.0 mm (.118") thickness 7. Install check ball (17) into valve body (20). See Figure 4-17. Install spring (14) on top of check ball. Spring length is 20.1 mm (.79"). Install O-ring (13) and thread plug (11) into valve body. 12.
Place gasket (21) and cover (19) on valve body (20). Install bolts and tighten to a torque of 6 Nm (4.4 ft lb). 13. Insert check ball (5) and spring (9) into valve body (20). Spring length is 20.1 mm (.79"). FIGURE 4-17 4456 8. Install check ball (16) into valve body (20). See Figure 4-17. Install spring (15) on top of check ball. Spring length is 20.1 mm (.79"). Install O-ring (12) and thread plug (11) into valve body. 4-10 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual